205
Troubleshooting Guide
Set the lens focus mode switch to <AF> (p.31).
To prevent camera shake, hold the camera still and press the shutter
button gently (p.34, 35).
If the lens has an Image Stabilizer, set the IS switch to <1>.
If a card error message is displayed, see page 30 or 209.
Set [8C.Fn II -2: High ISO speed noise reduction] to one of the
following settings: [Standard/Low/Disable]. If it is set to [Strong], the
maximum burst will greatly decrease (p.176).
If you shoot a subject which has minute details (field of grass, etc.), the
file size will be larger and the maximum burst will be lower as
mentioned on page 55.
If [8C.Fn II -3: Highlight tone priority] is set to [Enable], the
settable ISO speed range will be ISO 200 - 6400. When [Disable] is
set, you can set any ISO speed (p.177).
If you shoot night scenes, the shutter speed becomes slow
automatically (slow-sync shooting) so that both the subject and
background are properly exposed. If you do not want a slow shutter
speed to be set, set [8C.Fn I -7: Flash sync. speed in Av mode] to
1 or 2 (p.175).
The image is out of focus.
The card cannot be used.
The maximum burst during continuous shooting is lower.
ISO 100 cannot be set.
When I use the <f> mode with flash, the shutter speed
becomes slow.
To Next Page
Loading...
