Chapter 5
5-10
##287 [TX] DCN has been received after transmitting MPS
##288 [TX]
After transmitting EOP, a signal other than PIN, PIP, MCF, RTP, or RTN
was received
##289 [TX]
After transmitting EOM, a signal other than PIN,PIP,MCF, RTP, or RTN
was received
##290 [TX]
After transmitting MPS, a signal other than PIN,PIP,MCF, RTP, or RTN
was received
##332 [TX/RX] Printer control DRAM check error
##333 [TX/RX] Printer control ROM check error
##334 [TX/RX] Printer control EEPROM check error
##335 [TX/RX]
Data transmission error between the system control section and printer
control section
##336 [TX/RX] BJ head abnormal temperature error
##337 [RX] BJ head temperature sensor error
##338 [RX] Printing Position Correction Failed
##339 [RX] BJ Head Voltage Malfunction Error
##340 [RX] Home Position Error
UN
Q ##341 [TX/RX] Maintenance Jet Waste Ink Tank Full
UN
Q ##342 [TX/RX] Cleaning absorption waste ink capacity full
UN
Q ##343 [TX/RX] Ink Detection Waste Ink Tank Full
##346 [TX/RX] Inside temperature error
NE
W ##352 [RX] Printer control EEPROM head information error
##670 [TX]
In V.8 late start, the V.8 ability was detected in DIS from the other party
and, in response, CI was transmitted; however, the procedure failed to
advance, causing a T1 time-over condition
##671 [RX]
In V.8 call arrives, the procedure fails to advance to phase 2 after CM
detection, causing a T1 time-over condition
##672 [TX]
In V.34 transmission, the procedure fails to move from phase 2 to phase
3 and later, causing a T1 time-over condition
No. Tx or Rx Definition
Download Service Manual And Resetter Printer at http://printer1.blogspot.com
To Next Page
Loading...
