3
35
English
To perfom the reset please do as follows:
1
To enter the menu, press the "M" button�
2
Use the " " or " " button to navigate to the menu Wireless Setup [WIS] and confirm with the "OK" button�
3
Use the " " or " " button to select the item Wireless Reset [WRE] and confirm with the "OK" button� The menu Wireless Reset is displayed and the status
indication should show "No", the display shows [NO]�
4
If you want to cancel the reset precedure, press the "OK" button, or press the "M" button�
5
If you want to perform the reset, select "Reset all" using " " or " " key and press the "OK" button� The display shows [YES]�
6
The OSD shows “Please Wait”, the display still shows [YES]. After a few seconds the Soundbar 10 jumps back to the menu "Wireless Setup"�
7
Press the "M" button to exit this menu item�
RF Power [TXP]
The wireless audio module of the Sound M is by default set to 25% of the maximum transmission power [ECO], according to -6dB� In most cases, this
is completely adequate for a stable and non-interrupted wireless connection with Smart speakers and/or a Smart subwoofer in the same room� In
case of connection problems and/or audio dropouts you can increase the transmission power� At Medium setting [MED] the transmission power is at
50% (-3dB) and at [MAX] at 100% (0dB)�
To adjust the transmission power of the wireless audio module please do as follows:
1
To enter the menu, press the "M" button�
2
Use the " " or " " button to navigate into the menu Wireless Setup [WIS] and confirm with the "OK" button�
3
Use the " " or " " button to select the item RF Power [TXP] and confirm with the "OK" button�
4
Select the desired transmission power using the "+" or "–" button and confirm your selection by pressing the "OK" button�
"ECO" / [ECO] = 25% (-6dB) "Medium" / [MED] = 50% (-3dB) "Max" / [MAX] = 100% (0dB)�
5
Press the "M" button to exit this menu item�
RF Channel [CHN]
Usually the wireless audio module of the Sound M choses a free radio channel in the 5�2GHz resp� 5�8GHz band automatically (AUTO / [AUT])� In
case you use your WiFi in the 5GHz band too and dropouts in the audio transmission occur, this gives you the option to set the radio frequency of
the wireless audio module to a specific channel�
If you select a different specific channel for your WiFi-router too, interferences and dropouts should no longer occur�
The selected frequency for the Sound M and the router should ideally be as far apart as possible� The Sound M uses the following radio channels:
• 5�2GHz Band: 5�2G-1 = 5180MHz 5�2G-2 = 5210MHz 5�2G-3 = 5240MHz
• 5�8GHz Band: 5�8G-1 = 5736MHz 5�8G-2 = 5762MHz 5�8G-3 = 5814MHz
To Next Page
Loading...
Need help?
General
Weight and Dimensions
