CanyCom S25A - Tool Bag Contents

Specifications
-18-
3
Model and Type
S25A
One-side-Dump Turn & Dump
Travel
Speed
High Speed km/h 0 to 11
Low Speed km/h 0 to 6
Minimum Turning Radius m 2.0
Gradability Degrees 30 (unloaded)
HST Oil Capacity L 36
Drive Train
Main Transmission HST (2-Speed Motor)
Steering System 2-Pump/2-Motor System
Brakes Hydraulic
Dumping System
Dump System Hydraulic Dump
Load Deck Type One-side-Dump Turn & Dump
Hydraulic
Pump
Type Gear Pump
Max. Speed rpm 2,800
Max. Discharge L/min 31
Relief Pressure MPa(kgf/cm
2
) 15.7 (160) 11.8 (120)
Cylinder(Bore X Stroke) mm 80 X 407
Performance
Max. Angle Degrees 60 85
Lifting Time Sec approx. 4.0 approx. 7.4
Lowering Time Sec approx. 3.0 approx. 5.3
Hydraulic Fluid Capacity L Shared with HST System
Swivel System
Swivel System - Hydraulic (Twin cylinder)
Swiveling Angle Degrees - 90(Right) - 90 (Left)
Swiveling Time Sec - approx. 6.0
Cylinder(Bore X Stroke) mm - 60 X 250
*These specifications are subject to change without notice.
Performance and Operating Range
No. Content Quantitiy Note
1 Operator's Manual 1 This Manual
2 Operator's Manual for the Engine 1
Contents of the Tool Bag