Troubleshooting
• If any malfunction or abnormal condition is found, immediately stop using the
machine and take an appropriate measure according to the Troubleshooting chart
below. If the malfunction or abnormal condition is not listed in the chart, or the
suggested measure does not solve the problem, consult with your CANYCOM
representative.
• Some corrective measures listed below require special knowledge and/or
equipment. Please contact your CANYCOM representative in such a case.
Area Malfunction Possible Cause Corrective Measure Ref.
Engine
Engine does not start,
or is difficult to start
Out of fuel. →Fill fuel. Page 19
Air in fuel system. →Bleed air. Page 48
Water in fuel. →Drain water. Page 48
Battery is discharged. →Add battery fluid.
→Charge battery.
→Replace battery.
Page 58
Battery cable is
disconnected.
→Connect battery
cable.
Bad connection or
breakage in the wiring.
→Please contact
your CANYCOM
representative.
Starter switch, relay or
motor is defective.
→Please contact
your CANYCOM
representative.
Insufficient or wrong
oil.
→Fill or change oil. Page 42
Other (other than the
above).
→Please contact
your CANYCOM
representative.
Engine stalls
Out of fuel. →Fill fuel. Page 19
Air in fuel system. →Bleed air. Page 48
Cold engine. →Warm up engine.
Other (other than the
above).
→Please contact
your CANYCOM
representative.
To Next Page
Loading...