8. Move throttle lever to [ (slow)] position.
9. Make certain the warning lamps are not lit.
10. Allow the engine to warm up by running
it for 3-5 minutes without any load. (It is
not necessary when the engine is already
warm.)
• Drive the machine gently in the first 40 to 50
hours of use after purchase for breaking-in.
• If any of warning lamps is lit, stop the
engine immediately and investigate the
cause.
NOTE
Driving
• Do not allow bystanders to come near the machine when driving.
• Always make certain of the safety of your surroundings before driving; start
slow.
• Always stay seated in the operator's seat when driving the machine. Never
operate the steering lever off of the machine. This may cause the machine to
run over or crush the operator.
• Always make certain of the safety of your surroundings before turning
• Do not make sudden starts, acceralation, change of speed, change of direction,
or stop. Do not turn at speed. Avoid sudden maneuvers; this may cause the
operator to fall or to be thrown, or the machine to tip over.
• Do not turn the key to [ (off)] position while traveling. Machine can lose
stability and tip over.
To Next Page
Loading...