1. Open engine hood.
2. Make sure the components in the fuel
system is securely installed.
3. Fill fuel in fuel tank.
Bleeding Air in the Fuel System
Bleed air when air enters the fuel system
• After changing fuel filter or disconnecting fuel line.
• After running engine until fuel tank is completely dry.
NOTE
4. Open side cover (page 44).
5. Loosen air bleed plug.
6. Turn main switch to [ | (ON)] position to
actuate fuel pump.
7. When fuel comes out of air bleed plug,
tighten plug.
8. Close side cover and engine hood.
• Fill enough amount of fuel so that air is not
sucked into the fuel system.
NOTE
1. Open side cover.
2. Visually inspect water in fuel bowl. If it
reaches limit line or above, drain water.
3. Close side cover.
Inspecting Water in Fuel
1. Open side cover.
2. Close fuel cock.
3. Follow Operator's Manual for the Engine to
remove fuel bowl and discard its content.
4. REinstall fuel bowl.
5. Open fuel cock.
6. Close side cover.
Removing Water in Fuel
To Next Page
Loading...