8200-M035-O1 Rev C ļ 200 Installation & Technical
KEYPAD FUNCTIONS, CONT.
ASTERISK, PRINT KEY
This combination is used to change the selected print ticket format. Pressing the
ASTERISK then the PRINT key will display a prompt "Prt=". Press the
TARE/ENTER key to show the current value. If the setting displayed is acceptable,
press the TARE/ENTER key again to save it. Otherwise, press the ASTERISK/UP
ARROW key to "toggle" between the different available values, then press the
TARE/ENTER key to save it. Allowable values are:
1 = visual ticket format 1
2 = visual ticket format 2
NOTE: When a print format is selected, it will remain active until changed
by the operator.
PRINT KEY
Pressing this key will add the displayed gross or net weight to the associated accumulator and
initiate the transmission of weight and other data depending on the Print Tab Settings (see
example) via the selected printer output port (see Port= under Print menu) unless the
continuous data feature of this port was enabled during setup and calibration. Note that the
indicator will not respond to this command unless the weight display is stable. If displaying
gross weight, the only weight printed is gross weight. If displaying net weight, the gross, tare,
and net weights will print.
The 200 includes support for visual tickets. Visual
tickets are designed by the PC based programs Visual
Print or n Control, then downloaded to the indicator.
The 200 allows two programmable formats in addition
to the standard print tab settings format.
Print formats are selected by using the ASTERISK and
PRINT keys in combination (refer to the previous
section for details). NOTE: When the PRINT key is
pressed the indicator looks for the selected format. If
no visual ticket is found it reverts to the print tab
settings.
#2
100.00 lb G
20.00 lb T
80.00 lb N
0.00 lb GROSS ACCUM
272.00 lb NET ACCUM
To Next Page
Loading...
