Cardinal 200

8200-M035-O1 Rev C  200 Installation & Technical
45
SETUP REVIEW
The Model 200 Weight Indicator allows several operational parameters to be reviewed and
changed without breaking the calibration seal. These operational parameters are:
Power Up Zero Reset Enable/Disable
Sleep Mode Feature Enable/Disable
Auto Shutoff Feature Enable/Disable
Clear Tare Feature Enable/Disable
Serial Input / Output Configuration
Baud Rate
Parity
Number of Data Bits
Number of Stop Bits
Continuous Output Port 1
Continuous Output Format
Type
Continuous Output Port 2
Continuous Output Format
Type
Print Tab Settings
Printer Port Selection
Gross Weight
Tare Weight
Net Weight
Gross Weight Accumulator
Net Weight Accumulator
CRLF Data Format Termination
End-Of-Print Line Feeds
To enable the Setup Review feature, with the indicator ON:
1. Press the ASTERISK/UP ARROW key. The indicator will respond by showing the
FUnCt= (Function) prompt and alternately flashing off and on (all ON, weighing unit off,
then all OFF, weighing unit ON) the annunciators.
2. Press the ZERO/REVIEW key. The display will change to the prompt for the selection of
power-up zeroing (PUO=).
3. Using the same procedure as described in the Setup and Calibration section of this
manual make the required changes.
4. Press the ASTERISK/UP ARROW key to return to the previous prompt.
5. To exit Setup Review, press the ASTERISK/UP ARROW key to step through the
remaining prompts OR at anytime, cycle the power (press the ON/OFF key twice).