8527-0544-2M Rev G ļ APS Enterprise Scale 6
INSTALLATION, CONT.
(APS250 ONLY)
Unpacking and Setup, Cont.
6. Determine where the scale is to be located. It should be a smooth surface capable of
supporting both the scale and any load to be placed on the scale. It should not be in direct
sunlight nor should it be subject to air flow from heating/cooling vents, fans or similar
devices.
7. Plug-in 12VDC adapter to use scale. Refer to Electrical Power section of this manual for
more instruction.
8. The scale is now ready for use.
Level Adjustment
Place the scale in the chosen location and remove the stainless steel platform. The platform
can be removed by lifting upward on it removing it from the weighbridge. Locate the small
level indicator on the scale base to the right of the display and check to make certain that the
scale is level.
NOT LEVEL LEVEL
Bubble is not Bubble is
within circle within circle
If the level indicator does not show a level indication, the mounting feet should be adjusted to
obtain a level condition. To adjust a mounting foot, first loosen the lock nut (located under the
scale base) and then turn the mounting foot in the required direction to raise or lower that
corner of the scale. Once a level condition has been achieved, secure the mounting foot
settings by tightening each of the lock nuts. Replace the platform on the weighbridge.
MOUNTING FOOT
LOCK NUT
To Next Page
Loading...
Need help?
General