To Next Page

To Previous Page

CALIBRATION

Your ProDoc Series Scale was calibrated at the factory and should not require adjustment. In

the event that the scale should need re-calibration, the following describes the calibration

procedure. To maintain the instrument’s high degree of accuracy, a qualified technician should

perform this function.

Before beginning calibration, the following equipment is required:

150 kg (330 lbs) of calibrated test weight

To Enter Calibration

1. With the scale off, press and hold the ZERO and the BMI HEIGHT/ENTER keys and then

press the ON/OFF key.

2. The display will turn on all digits, show the software version for a few seconds, show CAL

for a few seconds and then change to show USA_ (where _ is the current setting).

3. Release all keys.

4. The scale is now ready for calibration.

IMPORTANT! When a prompt and its value displayed are acceptable, press the

BMI HEIGHT/ENTER key to retain the current setting and proceed to the next

prompt. To change a setting, press the RECALL or STORE keys to select a

new value and then press the BMI HEIGHT/ENTER key to save the new value and

advance to the next prompt.

USA_  Set Zero Limit

This prompt selects whether the scale is used in the USA and has a zero limit or outside the

USA with no zero limit.

If the value displayed is acceptable, press the

BMI HEIGHT/ENTER key and proceed to the next

prompt. Otherwise, press the RECALL or STORE keys to select a new value and then

press the BMI HEIGHT/ENTER key to save it and proceed to the next prompt.

0 = +/- 2% Limit (with +9d

max capacity)

1 = No Limit (with +4%

max capacity)

HoLd_  Hold Mode (Lock Feature)

If the value displayed is acceptable, press the

BMI HEIGHT/ENTER key and proceed to the next

prompt. Otherwise, press the RECALL or STORE keys to select a new value and then

press the

BMI HEIGHT/ENTER key to save it and proceed to the next prompt.

0 = Disabled 1 = Enabled

NOTE! The Hold Mode (lock feature) is for non-commercial applications and

must be disabled for "Legal for Trade" applications.

0044-M340-O1 Rev C  ProDoc Series

Cardinal Detecto ProDoc PD100 User Manual

Questions and Answers: