caron 6540 - C - Chart Recorder Parameters

6540 Series Operations Manual Rev_I 1/12/2016 64
APPENDIX C – CHART RECORDER (REC-203, REC-204)
Recorder inputs are configured as listed below
6540-1, -2, -3
6545-1, -2, -3
Recorder P/N
REC-203 CE
REC-204 CE
# of inputs
3
4
Input #1
Temperature
Temperature
Input #2
Light meter 1
Light meter 1
Input #3
Light meter 2
Light meter 2
Input #4
Humidity
Recorder pens are the same for all recorders and are configured as listed below
Pen 1
Temperature
Pen 2
Light meter 1
Pen 3
Light meter 2
Pen 4
Humidity
Press the SETUP button to scroll through the group menus.
Press the FUNC button to scroll through a particular group.
Press the UP & DOWN arrow buttons to change the current parameter
Press the CHART button to temporarily put the chart on ‘hold’. Pressing CHART again will resume.
Press the LOWR DISP button to scroll through the input variables.
To increment a numerical value, press & hold the UP arrow key. While holding the UP arrow key, press the DOWN
arrow key to move cursor to the next digit location.
To decrement a numerical value, press & hold the DOWN arrow key. While holding the DOWN arrow key, press the
UP arrow key to move cursor to the next digit location.
Factory default settings are as follows:
Parameter
Analog Output Range
Corresponding Value
Temperature
0 – 5 V
-176 to 208°C
UVA
0 – 5 V
0 to *
VIS
0 – 5 V
0 to *
Humidity
0 – 5 V
0 – 100 %rh
*Value is unit specific, see figure on page 69