Carrier 58HDX - Page 25

Trap Connection Single Pressure Switch Detail
“Clamp ears” .
Pointed OUT
Alternate Orienta-
Plastic Cap
Yellow or black
Coupling & Clamps
Preassemble & (Optional)
insert
into
furnace
-
. ~ ~S~sFieta
| WARNING Vent Drain _ <t Supplied Tee
Add
Cap
and
&
Clamps
:
=
Clamp = Lu
\
N
i/
pepe Nef é y Tee Trap
Relief Tube Rubber Tube " ~\ White PVC
3/46” ID | (loose parts bag)
Flexible Tubing Connector
3/45”
OD
(Loose
Parts
Bag)—_
be
.
~
Elbow
Tube
Black
Rubber
1/,”
_ ID & Clamps (Loose Parts Bag)
INLET <=)
k St
Relief Tube Extension
Black Rubber 3/;,” ID ,
Cut to Fit (Loose Parts Bag)
On Some Models
ONLY
Dual Pressure Switch x | Barbed Coupling 1/.” OD
(Loose Parts Bag)
Drain Tube Black Rubber
ye
Drain Tube Corrugated 5/,” ID & Clamps Ip" ID & Clamps
Cut at straight section
Leave room for clamp Cut Here
Representative drawing only, some models may vary in appearance.
A07711
Fig. 17 - Horizontal Right through Top
Horizontal Right th rough Top (See Fig. drain tube in the loose parts bag. Cut tube to length. Secure
1 7) connections with clamps.
3," : :
¢ Disconnect the hoses from the trap assembly, and remove trap Connect the “/16" (5 mm) ID relief tube to the middle port on
the trap. If an extension is required, use the clear 3/,6"(5 mm)
OD flexible tubing connector and the black 3/1¢”(5 mm) ID
relief tube in the loose parts bag. Cut tube to length.
and trap mounting bracket from the blower compartment.
Using cover plate and gasket provided in the loose parts bag,
cover the hole from the burner compartment to the blower
compartment and secure with screws. Cut an appropriate length of 2” (51 mm) PVC pipe, fittings
and extension pipe long enough to exit the cabinet and connect
¢ Remove knockout from the side of the furnace casing where
the vent drain to a standard field supplied 2” (51 mm) PVC tee
drain tube will exit.
¢ Mount the trap externally to the bottom side of the unit using Install tee trap into bottom section of tee.
the 2 screws provided in the location shown. Connect the tee trap and the main drain line exiting the casing
as shown in Fig. 19.
NOTE: It is recommended that all PVC piping and fitting
Secure connections with clamps. connections be fit up and inspected before final cementing. Both
Lone . the external trap and the external tee trap must be primed before
* Connect the black '/2" (13 mm) ID drain tube from the Vent operation. Verify all condensate drain connections are securely
Drain to the trap. If an extension is required, use the black !/5” clamped. A coupling and clamps (in loose part bag) may be
(13 mm) OD barbed coupling and the black !/."(13 mm) ID installed as shown for future servicing of the vent system.
¢ Cut the corrugated tube as shown in the illustration above.
Connect the corrugated hose from the transition to the trap.
25