134 Installation and Programming Guide
Appendix 1: System Status Messages
Various messages may appear on the Status screen of Aritech Reliance XR Web Server and
UltraSync+ app.
• AC power fail – The security system has lost its electricity power. May take up to 5
min to clear once power restored.
• Low battery – The security system’s back up battery requires charging. May take up
to 5 min to clear once battery charged.
• Battery test fail – The security system’s back up battery requires changing. If after 48
hours this message does not clear, replace with a new battery. If the power fails, the
system will not be operational.
• Box tamper – The security system’s cabinet tamper input is open or either antenna is
not connected.
• Siren trouble – The security system’s external siren has a problem. Check the panel is
securely installed on the wall.
• Over current – The security system is drawing too much current. Disconnect some
hardwired inputs.
• Time and date loss − The security system time and date need resetting.
• Communication fault – The security system has detected a problem with the
communication channel. Check the internet connection, Ethernet cable, or cellular
reception is sufficient.
• Fire alarm – A fire alarm has been activated from the panel.
• Panic – A panic alarm has been activated from the panel.
• Auxiliary – An auxiliary alarm has been activated from the panel.
• Is on in the away mode – This Area is armed in the away mode.
• Is on in the stay mode – This Area is armed in the stay mode.
• Is ready – This Area is secure and ready to be armed.
• Is not ready – This Area is NOT ready to be armed, a zone is not secure.
• All Areas are on in the away mode – All Areas in this multi area system are armed in
the away mode.
• All Areas are on in the stay mode – All Areas in this multi area system are armed in
the stay mode.
• All Areas are ready – All Areas in this multi area system are secure and ready to be
armed.
To Next Page
Loading...
