Installation and Programming Guide 29
Enrolling Modules
New devices such as zone expanders, wireless zone expanders, output expanders, smart
power supplies, and keypads need to be enrolled so they can be programmed and
supervised.
The enrollment procedure discovers the serial number of the new device and adds it to the
device database in the panel.
To enroll a module:
1. Press and hold the LEARN button until the LED next to the button blinks, then release
button.
2. The panel is now in automatic enrollment mode and will search for new devices.
3. The D5 LED will stop blinking to indicate enrollment mode is finished.
4. Proceed to programming the system and the additional devices.
Enrollment can also be initiated:
• Using the NXX-1820 keypad: press Menu – [Installer PIN] – [ENTER] – Program –
Devices – System Devices – Control – Enroll Function – 0 = Inactive – Automatic
Enroll.
• Using the Aritech Reliance XR Web Server: click the Advanced Menu, click Devices –
System – Control – Enroll Function – Automatic Enroll – Save.
• Using DLX900: click Devices – Device Info – Auto Enroll.
Deleting Modules
Devices such as zone expanders, output expanders, and keypads can be removed from the
system by deleting the serial number from the device database.
To delete a module:
1. On the keypad press Menu – [Installer PIN] – [ENTER] – Program – Devices.
2. This menu will be displayed:
1. System Devices
1. Control
2. Keypad
3. Zone Exp
4. Output Exp
5. Power Supply
2. ARITECH Transmitters
1. Transmitter Number
2. Serial Number
To Next Page
Loading...
