22 Installation and Programming Guide
Aritech Reliance XR Pro LEDs
Top to bottom:
• D5 RF – red LED blinks when message
sent / received from a 63bit / 80plus
transmitter.
• D7 LAN – green LED is lit when connected
to UltraSync, remains off when not
connected to UltraSync.
• D4 LEARN – red LED blinks slowly during
auto enrollment, blinks quickly during
manual enrollment.
• D3 XR BUS – red LED blinks to indicate
Aritech Reliance XR bus is available.
• D1 ETHERNET – red LED is lit when
Ethernet cable is connected to WAN port,
blinks when data is sent or received, and
is off when cable is disconnected or J14
connector is removed.
If 4G / WiFi router module is installed,
LED is lit when panel has established
connection to the module, and blinks
when panel is communicating with the
module.
Check “Connection Status” web page to
verify connection to UltraSync.
To Next Page
Loading...
