Installation and Programming Guide 39
Method 2: Web Server
Aritech Reliance XR has a built-in web server which makes it easier to program using a web
browser instead of a keypad. Features include:
• Simple forms to set up commonly used features
• View system and zone status
• Arm and disarm areas
• Bypass/Un-bypass zones
• Turn chime mode on and off
• Add, delete, and edit users
• Access to the advanced programming menu
Connect to Aritech Reliance XR Web Server over LAN
1. Turn on power to your system.
2. Connect an Ethernet cable to an available port on a router. Ideally this router has access
to the Internet.
3. Connect the other end of the Ethernet cable to the J13 Ethernet port on the Aritech
Reliance XR. Wait 10 seconds for the router to assign the Aritech Reliance XR an IP
address if DHCP is available.
4. On the keypad press Menu – [PIN] – [ENTER] – Installer – Communicator – IP
Configuration – IP Address and note the IP address displayed.
5. Connect your device to the same network (e.g., via WiFi or Ethernet cable).
6. Open a web browser
7. Enter the IP address from step 3 and the Aritech Reliance XR login screen should
appear. Some browsers may require you to enter http://
8. Enter your username and password, by default this is installer and 9713.
9. You should now see a screen similar to:
To Next Page
Loading...
