Installation and Programming Guide 75
Programming with DLX900
This section of the manual will describe the steps needed to program each feature using
the DLX900 software.
Selected screen shots of the Aritech Reliance XR Web Server are also included for your
reference. Similar screens appear on the UltraSync+ app.
Programming Instructions for System Options
Goal
Program System Options including time and date, tamper, siren, timers, and service
settings.
Pre-conditions
Time and date are automatically updated using a internet time server by default, this
setting is enabled under Communicator – IP Config.
If you want to allow Aritech Reliance XR to send diagnostic emails, then check email is set
up correctly under Communicator – Email and Aritech Reliance XR is connected to a
network.
Note: Ensure you set the correct time zone here.
Programming Sequence
Instructions
1. Open System
To Next Page
Loading...
