62-11389
6−4
MessageCenter MESSAGES - Continued
Message Description
MICRO WILL STOP IN XXX SECONDS The Main Power switch has been placed in the OFF position and
the system valves are closing. The display will turn off when the
count down reaches zero.
MIN SETPOINT HAS BEEN REACHED Minimum Set Point allowed by configuration settings has been
reached.
MODIFIED This message will appear in the MessageCenter along with the cur-
rent IntelliSet indicating that the IntelliSet is active and one or more
of its settings have been modified.
NEW SW: = TO LOAD, TO ↑ CANCEL A Program PC Card has been inserted into the PC Card slot, and
the program on the PC Card is a newer version than what is al-
ready loaded in the microprocessor. Press the = key to load the
program.
NO ACTION TAKEN, REMOVE CARD A Program PC Card has been inserted into the PC Card slot, and
no key presses have been made to install the program into the mi-
croprocessor. The PC Card may be safely removed from the slot.
NO ACTIVE ALARMS There are no active alarms in the microprocessor Alarm List.
NO DATA ON CARD, REMOVE CARD A Program or Configuration PC Card has been inserted into the PC
Card slot, and no valid data is present on the PC Card. The PC
Card may safely be removed from the unit.
NO DATA TO COPY, REMOVE CARD A Download PC Card has been inserted into the PC Card slot, and
there is no valid data in the DataLink data recorder to copy onto the
PC Card. The PC Card may safely be removed from the unit.
NO INACTIVE ALARMS There are no inactive alarms in the Alarm List
NO INSTALLS LEFT, REMOVE CARD An Option PC Card has been inserted into the PC Card slot, and all
install options have been used. The PC Card may safely be re-
moved from the unit.
OLD INTELLISETS-USE REEFERMAN The IntelliSets that are on the Configuration PC Card were written
with too old of a PC Program, like ServiceManager. The software in
the micro requires IntelliSets to be written to the Configuration PC
Card using ReeferManager. Rewrite the information to the card us-
ing ReeferManager, then use it in the microprocessor again
OLD SW:CANNOT LOAD-REMOVE CARD A Program PC Card has been inserted into the PC Card slot, and
the major version of the program on the PC Card is an older vers-
ion than what is already loaded in the microprocessor. Software
with older major versions can not be loaded into the micropro-
cessor. Remove the PC Card.
OLD SW, = TO LOAD, ↑ TO CANCEL A Program PC Card has been inserted into the PC Card slot, and
the minor version of the program on the PC Card is an older ver-
sion than what is already loaded in the microprocessor. Press the =
key to load the older program.
PC MODE The Main Power switch is in the OFF position, the PC Mode Jump-
er is connected and engine is not running in order to enter PC
Mode.
PM DUE Preventative Maintenance is now due on the unit.
PRESS ↑↓ TO VIEW DATA Press the UP or DOWN ARROW key to scroll through the Data
List.
PRESS ↑↓ TO VIEW SETTINGS Press the UP or DOWN arrow key to scroll through Functional Pa-
rameter Settings.
PRESS ↑↓ TO VIEW PRINT MENU Press the UP or DOWN arrow key to view the Strip Print setup
menu.
PRESS = TO MARK TRIP START Press the = key to mark the start of the trip in the DataLink data
recorder.
PRESS = TO START PRETRIP Press the = key to begin Pretrip tests.
PRESS ↑↓ TO VIEW INTELLISET Press the UP or DOWN arrow key to view IntelliSet list. This mes-
sage will appear after IntelliSets are installed into the micropro-
cessor, and the unit can not be started until an IntelliSet is selec-
ted.
To Next Page
Loading...
