62-11389
3−14
3.10 TRIP START
COOL DEFROST ALARM START‐STOP
ALARM LIST
SELECT
MANUAL
DEFROST
HEAT CONTINUOUS
TRIP START ENTERED
START‐STOP/
CONTINUOUS
2. Press the = key.
3. If trip start is acknowledged by the DataLink data recorder, “TRIP START ENTERED” will be displayed
for five seconds and then the display will revert back to the normal display. Otherwise “CANNOT EN-
TER TRIP START” will flash and then the display will revert back to the normal display.
1. To mark the start of a trip in the DataLink data recorder, press the SELECT key until
the MessageCenter displays “PRESS = TO MARK TRIP START”.
SETPOINT BOX TEMPERATURE
+34.5 F
-20.0
Trip Start places the present time and date as a stamp in the DataLink data recorder memory to allow easy review of
the data from the last trip, and to allow downloading data from a specific trip. A trip begins at a Trip Start and ends at the
next Trip Start.
To Next Page
Loading...
