8−5
62-11389
Table 8−2 Pre Trip Inspection - Continued
OPERATE UNIT IN HIGH SPEED COOL AND RECORD (From Microprocessor Unit Data)
Suction Pressure Battery Voltage Unit Model #
Discharge Pressure Current Draw (DC) Fuel Level*
Evaporator Pressure Engine RPM Hrs to Engine Maint
Engine Coolant Temp Unit AC Current #1 Hrs to S/B Motor Maint
Return Air Temp Unit AC Current #2 Hrs to Unit Maint
Supply Air Temp CSMV % Time Left to PM1*
Delta-T EVXV % Time Left to PM2*
Ambient Air Temp Software Rev Time Left to PM3*
Defrost Term Temp Display Software Rev Time Left to PM4*
Suction line Temp Controller Serial # Time Left to PM5*
Evap Outlet Temp Trailer/Vehicle/Car ID #
Datalogger (DataLink
data recorder) Date/
Time
Compr Disch Temp Unit Serial #
* Display is optional, record if displayed.
FINAL OK ADJUST
Review Functional Parameters j j
Download DataLink data recorder (if required) j j
Enter Trip Start In Microprocessor j j
8.4 EXTERNAL SURFACE SERVICE
Procedures for servicing or maintaining the grille,
surround, doors, door latches and display & keypad
assembly are provided in the following sub-paragraphs.
8.4.1 Grille Insert Removal
To remove the grille insert, do the following.
NOTE
If difficulty is experienced when attempting to
remove the grille mounting bolts, the grille may
be removed with the surround attached to allow
access to the mounting clips. (Refer to Section
8.4.2.)
a. Ensure the unit will not start automatically by dis-
abling any two way communication and placing the
Main Power switch in the OFF position. Disconnect
the high voltage source and lockout/tagout the re-
ceptacle.
b. Remove the 3 grille insert mounting bolts on each
side of the grille insert, See Figure 8−1
c. Remove the 2 grille insert mounting bolts on top of the
grille insert.
d. The grille is fitted with locating tabs along the bottom.
To remove, swing insert down and lift out of locating
slots.
e. Reverse above steps to install grille insert.
LUBRICATE LATCHES AND PINS
GRILLE INSERT MOUNTING BOLTS
SURROUND
GRILLE INSERT
Figure 8−1 Grille Insert Removal And Door Latch
Maintenance
8.4.2 Surround Removal
NOTE
It is not necessary to remove the grille before
removing the surround.
To Next Page
Loading...
