5. COMPUTER SETUP
The DCM-Lx has a USB port allowing use with Carvin’s Xdrive™ software.
5.A SOFTWARE
5.A.1 MINIMUM REQUIREMENTS
Windows: XP or later.
Mac: OS 10.6 or later.
5.A.2 INSTALLATION
Download the software from: www.carvin.com/xdrive
To install the Xdrive™ software for the DCM-Lx:
1. Unzip the files to a directory on your Hard Drive. There is 1 file:
"Setup.exe"
2. Run the Setup.exe file to install the Xdrive™ Serial Control software on
your computer.
3. The software will be installed to the c:\Program Files\Carvin Xdrive
directory.
It is recommended not to change the install directory.
4. You will be asked if you would like a Desktop shortcut icon created.
It is recommended to do this to allow easy access to the program.
5. The Xdrive™ software is now ready to use by double-clicking the
Xdrive™ icon on your desktop. When linking to the DCM-Lx hardware, the
device should be connected via the USB cable and powered on before the
software is used.
18
To Next Page
Loading...
