7. MANUAL SETUPS
7.A 2-WAY (Biamp):
(a.) Press A/1 to enter OUTPUT mode.
(b.) Press Left or Right until the “CHANNEL 1 … LPF” screen is displayed.
(c.) Use Left/Right to choose LPF Freq.
(d.) Use Up/Down to change the LPF to 2.30kHz for CH.1
(e.) Press Right.
(f.) Press Up to change the LPF Type (ex.: Butter12).
(g.) Press B/2 channel 2
(g.) Press Right for the “CHANNEL 2 … HPF” screen.
(h.) Use Up/Down to change the HPF to 2.30kHz for CH.2
(i.) Press Right.
(j.) Press Up to change the LPF Type (ex.: Butter12).
(k.) Press Left or Right until the SOURCE screen is shown for CH.2.
(l.) Use Up/Down to choose A. (for CH.2)
*Note: With “Quick Setup” in the SYSTEM menu (3.A.1) this setup can be
done in only 4 steps.
SPEAKER CONNECTIONS:
OUTPUT 1: LF, frequencies below 2.30kHz (Signal from INPUT A).
OUTPUT 2: HF, frequencies above 2.30kHz (Signal from INPUT A).
________________________________________________________________
7.B Parallel Outputs:
(a.) Press A/1 to enter OUTPUT mode (CH, Number).
(b.) Press Left or Right until the SOURCE screen is shown.
(c.) Use Up/Down to choose A. (for CH.1)
(d.) Press B/2 for OUTPUT 2.
(e.) Use Up/Down to choose A. (for CH.2)
CONNECTIONS:
OUTPUT 1: Full range signal from INPUT A.
OUTPUT 2: Full range signal from INPUT A.
24
To Next Page
Loading...
