6.E OUTPUT SETTINGS
(bottom of screen)
6.E.1 LOAD/SAVE
Load preset output settings or save them to your computer.
6.E.2 OUTPUT CHANNEL SELECT
Buttons 1,2 ( 3,4 ) : Select to display the settings for each output.
The output’s curve will be highlighted if displayed on the Frequency Chart.
6.E.3 COPY/PASTE
Copy output settings from one output to another.
6.E.4 FLAT
Resets the Output GAIN to 0dB, PEQs flat, and HPF/LPF to 20-20kHz.
6.E.5 PHASE
Flip the phase 180 degrees. IN is normal, OUT is +180 deg.
6.E.6 LIMITER
Set the threshold for the Limiter (0db = min, -30dB = max).
6.E.7 DELAY
Set the delay time for the output. Right click to select units: mS, Ft, or M.
6.E.8 GAIN
Set output level from +12dB(full) to -68dB(off).
Set to 0dB to match the Input Sensitivity setting in UTILITY menu.
6.E.9 PARAMETRIC EQs 1-4
Each amp output has 4 bands of Parametric EQ.
Adjust the vertical sliders for:
GAIN: Boost or cut in dB
FREQ: Frequency in Hz
BW: Bandwidth or “Q” in octaves
The PEQs can also be adjusted in the Frequency Chart. (see 6.D.2)
6.E.10 HIGH/LOW PASS FILTERS (Crossover)
Set each crossover frequency with the sliders. Select filter type and slope
(dB/oct.) from the list in the white box. Select OFF for no frequency cutoff.
23
To Next Page
Loading...
Need help?
General
