CARVIN XDrive DCM2000Lx - Product Specifications; Input;Output and Power Specifications; Digital Signal Processing Specifications; General Unit Dimensions and Power

9. SPECIFICATIONS
INPUTS:
XLR IN: 20kΩ balanced, ground lift switch
2ch. amps add 1/4” TRS IN and XLR THRU in parallel
Maximum Input: +10dBu
OUTPUTS:
Output Connectors: 4-pin Twist-Lock (and binding posts on 2ch. models)
Frequency Response: 20Hz-20kHz +/-1.5dB
THD: <0.1% @50%, <0.2%@90%, <1%@ rated power (1kHz, EIA)
OUTPUT POWER: DCM2000Lx DCM2004Lx DCM3800Lx
2 channels: 8 Ω 350w 300w 700w
4 Ω 550w 500w 1150w
2 Ω 1000w - 1800w
Bridged: 8 Ω 1100w 1000w 2300w
4 Ω 2000w - 3800w
DIGITAL SIGNAL PROCESSING:
Multi DSP 48kHz/24 bit
30-band Graphic EQ (each input): 20Hz to 20kHz, +/-12dB in 0.5dB steps
Gain: +12dB to -68dB in 0.5dB steps
Source Routing with Amp Bridging
Phase: 0 or -180 degrees (in or out)
High pass and Low pass (Crossover) Filters:
Butterworth: 6, 12, 18, 24, 48 dB/oct.
Bessel: 12, 24 dB/oct.
Linkwitz-Riley: 12, 24, 48 dB/oct.
Limiter: 0dB to -30dB threshold, hard limiting in 1dB steps
Delay: 0-120mS in 21uS steps (0-120ft in 0.28in steps, or 0-40 meters in 7mm steps)
4-band Parametric EQ’s (per output): +/- 12dB in 0.5dB steps, 0.16 to 2.0 octaves(Q)
Global System settings:
Input sensitivity: 0.7, 1.0, 1.2, 1.4 or 2.0 Vrms
Turn On Mute: On/Off
Security Lockout with user-definable Password sequence
System Preset memory storage locations: 16
USB: “type B” jack, compatible with USB 1.1 or higher,
for internal firmware updates, or remote Xdrive™ software control
General:
Dimensions: 19”W x 3.5”H x 11”D (483mm x 90mm x 280mm)
Weight: DCM2000Lx, DCM2004Lx: 10 lbs (4.5 kg) DCM3800Lx: 15 lbs (6.8 kg);
Power: 100, 120 or 240 VAC models, 50/60Hz standard IEC inlet (V-lock™ compatible)
Internal fuses: SLOW BLOW
DCM2000Lx: 100V or 120V: 15A, 240V: 10A
DCM2004Lx: 100V or 120V: 15A, 240V: 10A
DCM3800Lx: 100V or 120V: 25A, 240V: 15A
WARNING: This product produces high sound pressure levels that could damage hearing.
Use with caution.
26