CARVIN XDrive DCM2000Lx - System Menu Operations; Accessing the System Menu; Quick Setup for System Configuration; System Type Configurations

4.A SYSTEM MENU
Press the SYSTEM button to open the SYSTEM menu.
Use the Left/Right buttons to move through the menu pages.
Press the SYSTEM button again to edit the setting with Up/Down.
Press EXIT to return to the channel screen.
4.A.1 QUICK SETUP
QUICK SETUP mode will allow you to quickly configure a full system, without
having to set routing and crossover parameters from each Output screen.
(a.) Press SYSTEM, Right for “Quick Setup”, then SYSTEM.
(b.) Use Up/Down to select one of the SYSTEM TYPE configurations below.
(c.) Press SYSTEM.
(d.) Use Up/Down to set the crossover frequency.
ex.: Hi – Low Freq: 2.30kHz
(e.) Press SYSTEM to exit the QUICK SETUP mode.
Note: The default Crossover Filter Type: Linkwitz-Riley 24dB/Octave can be
changed in the Output Settings.
DCM2000Lx, DCM3800Lx:
Mono2Way: Mono 2-way (Bi-amp)
Input: A
Crossover: Low/High
Outputs: 1:Low(A), 2:High(A)
DCM2004Lx:
Str2Way: Stereo 2-Way (Two pairs of Bi-amp)
Inputs: A and B
Crossover: Low/High
Outputs: 1:Low(A), 2:High(A), 3:Low(B), 4:High(B)
Mono3Way: Mono 3-Way (Tri-amp)
Input: A
Crossovers: High/Mid, Mid/Low
Outputs: 1:Low(A), 2:Mid(A), 3:High(A)
Mono4Way: Mono 4-Way (hi / mid / low / sub)
Input: A
Crossovers: High/Mid, Mid/Low and Low/Sub
Outputs: 1:Sub(A), 2:Low(A), 3:Mid(A), 4:High(A)
3WbrgSub: 3-Way Bridge Sub (Tri-amp with amps 1&2 bridged for Sub)
Input: A
Crossovers: High/Low, Low/Sub
Outputs: 1/2 BRIDGE: Sub(A), 3:Low(A), 4:High(A)
St2BrSub: Stereo 2 way Bridged Sub (L/R + amps 1&2 bridged for Sub)
Inputs: A and B
Crossovers: High/Sub
Outputs: 1/2 BRIDGE: Sub(A+B), 3:High(A), 4:High(B)
8