“End Margin(30)” size is set.
If you use Continuous Label Paper in Label mode, “Gap length”
value is applied to “End Margin”.
* The values in ( ) are default.
Enter the “Gap(128)” and “Peel(128)” values for printing
sensor calibration.
* The values in ( ) are default.
* If you press “TEST” key, Gap and Peel values are adjusted
automatically.
* In case of Ticket mode, Gap value is not saved.
Sensor & Motor
Set Peel-off sensor and Label Paper type
Print Intensity
Set the extent of intensity of label (ticket) printed.
Set adjusting values of feed length.
This value can be from 0 to 400. You can change.
* Pressing “TEST” key automatically feeds to adjust the feed length.
You can set label preprint length.
Set adjusting values of reverse feed length.
This value can be from 0 to 400. You can change.
2.9.3.1 Print Mode (Menu code 1731)
( MENU → 7. Print → 3. Printer Hardware → 1. Print Mode )
Select “0” for Label Mode,
“1” for Ticket Mode or
“2” for Continuous Label Mode.
2.9.3.2 Label Size/Ticket Size (Menu code 1732)
(MENU → 7. Print → 3. Printer Hardware → 2. Label Size )
Enter values for “Width”, “Height”, “Gap Length”, ”Feed” and “End Margin”. If you
press “TEST” key, height and gap length of current label is measured.
To Next Page
Loading...
