CAS CL-3000 Series - Sensor Calibration (Menu Code 1733); Sensor & Motor (Menu Code 1734)

118
• If it is Continuous Label Mode, “CONT. LABEL SIZE” is displayed, and “TEST” key is
not operated. And “End Margin” instead of “Gap Length” shows up.
2.9.3.3 Sensor Calibration (Menu code 1733)
(MENU → 7. Print → 3. Printer Hardware → 3. Sensor Calibration )
Enter appropriate values for “Gap”, “Peel”, “Out of Paper”.
• If you press “TEST” key, Gap and Peel
values are adjusted automatically.
• If it is Ticket mode, “Gap” value is not
saved.
2.9.3.4 Sensor & Motor (Menu code 1734)
( MENU → 7. Print → 3. Printer Hardware → 4. Sensor&Motor )
Enter appropriate values or “Yes” or “No” for “Active peel-off”,
“Label paper”, and “Active Head up sensor”.
• If there is no gap on a label, set
Label Paper to 0, if there a gap, set it to 1.