CAS EC-II Series - Page 3

4
7. User Programming Functions
..................
42
A. Auto. Shut off time span
....................................
42
B. Backlight type
......................................................
43
C. Change unit of measure from kg/g to Pound44
D. Unit weight recomputing
..................................
45
E. Transmit method setting
....................................
46
F. Baud Rate setting
.................................................
47
G. Label format setting
(available when a label printer is connected.)48
H. Check alarm type
...............................................
49
I. Cancel Tare setting
...............................................
52
J. Remote platform setting
.....................................
53
K. Three section control signal
..............................
54
L. Transmit method of extra display
...................
55
M. Baud rate setting of extra display
...................
56
N. Zero Tracking Range
.........................................
57
O. Zero display Range
............................................
58
P. Stable class Range
................................................
59
Q. Stable class Rate
..................................................
60
8. Calibration(can only be done in kg/lb)
.
61
9. Power supply & battery operation
.......
63
10. RS-232 Output
.......................................
64
11. Error Codes
............................................
71
12. Technical Data
........................................
72