61
8. Calibration
● Turn on the scale, and key in “000419” during counting down(self-check)
to zero to enter into Simple Calibration mode.
The displays will indicate as below.
Press MOVE key to choose the taget platform(local or remote).
Then press ENTER key for determination and enter into unit selection.
● Press MOVE key to choose the unit for calibration (kg/g or lb).
Then press ENTER key for determination and enter into calibration mode.
Note : The weighing unit for local platform is g or lb, while the unit for remote
platform is kg or lb.
To Next Page
Loading...
