42
7. User Programming Functions
In counting mode, press SET key to enter into USER PROGRAMMING
FUNCTION MODE. After pressing “SET” key, the display shows “PASS WORD”
to prompt to key in a pass word “101010”, then press “Enter” key to confirm the
pass word.
If the pass word is wrong, then the scale can not to enter into User Programming
Function Mode.
★ The display shows “error” to prompt the mistake when the pass word is wrong.
★ If wrong pass word is entered for two times, then the scale will return to counting
mode automatically.
A. Auto. Shut off time span
When enter into “User Programming Functions” mode, the displays will
indicate as below eventually.
Press MOVE key to revolve the system-preset time span
(2 min., 5 min., 8 min., and OFF),
(Default setting : OFF)
Press CLEAR key to determine and return to normal counting mode or
press ENTER key for determination and move to next.
★ Turn off the scale to return to normal counting mode.
To Next Page
Loading...
Need help?
General
