Press ALARM key again and key in the desired low limit value as indicated
below. (Low limit value effective only after high limit is preset)
Press SMPL key to complete counting check range preset procedure and
return to normal counting mode.
Note : If it is in counting mode, press ALARM key again to set
count – check range.
Note : 1) An error massage “E5” appears when the LO value is set higher than
HI value.
2) When both HI and LO values are needed, they must be kept same decimal
digits. (Ex. HI=10g, LO=9.8g, then the values must be set as
“HI=10.0g, LO=9.8g”)
To Next Page
Loading...
Need help?
General
