39
Press ALARM key again and key in the desired low limit value as indicated
below. (★ Low limit value effective only after high limit is preset)
Press U.WT key to complete weight check range preset procedure and return
to normal counting mode.
Note : If it is in weighing mode, press ALARM key again to set weight – check
range.
Note : 1) An error massage “E5” appears when the LO value is set higher than
HI value.
2) When both HI and LO values are needed, they must be kept same
decimal digits. (Ex. HI=10g, LO=9.8g, then the values must be set as
“HI=10.0g, LO=9.8g”)
To Next Page
Loading...
Need help?
General
