DISTRIBUTION SYSTEMS - PRIMARY HYDRAULIC POWER SYSTEM
9. Reservoir - Apply vacuum (A.10.A.22 -
F.35.A .50)Loosen and remove the hydraulic hose
fitting from the top of the oil cooler. Install plugs and
caps on the fittings.
bd04c010 7
10. Loosen and remove the hydraulic hose fi tting from
the bottom of the oil cooler. Install plugs and caps
on the fittings.
BD04C006
8
11. Stop the vacuum pump.
12. Loosen and remove the hardware which fastens the
oil cooler to the chassis . Rem ove the o il cooler.
1 04/05/2005
A.10.A / 61
To Next Page
Loading...
