— 9 —
4. Remove both of the old batteries from the main battery holder, and load two new ones.
When loading new batteries, make sure that their positive (+) and negative (–) ends are facing correctly.
5. Insert the main battery holder into the A-10/A-11 until the holder is fully seated.
1
2
6. Slide the release (both buttons) of the main battery holder towards “NORMAL OPERATION” to lock the
main battery holder release.
7. If you are loading batteries into the A-10/A-11 for the first time after purchasing it, pull the insulating tape
out from under the back-up battery compartment cover according to the following order.
To Next Page
Loading...
