— 23 —
7-6. Fiscal ROM test
1) Fiscal ROM test
This test will check the fiscal ROM area for the test operation.
Opeartion : 1 X 7 #2 Key
X : 0= Fiscal ROM information print
1= Fiscal ROM data dump print
2= Fiscal ROM write test in the test area
3= VPP (Fiscal ROM write voltage) test
[PRINT]
Normal end
Fiscal Normal End
EPERR: 00
Test Rest No 0016
1 Way code FFFF
GT Free Area 2700
Sub ID:
9999999999999999
Note 1 : Fiscal ROM data dump print will print the data inside of the Fiscal ROM.
It will be printed out by 4 bytes unit. But, it will be skipped when the data is 0FFh.
During dump print time, "-" will be displayed at the left digit with brinking display.
Note 2 : Fiscal ROM wite test will write the test data in the test area. But, if the area is
not formatted, it will be error and test will be stopped. Also, if the test area is
empty, the machine will be error. After this test, the Fiscal ROM infromation print
will be preformed automatically.
Note 3 : VPP (Fiscal ROM write voltage) test will turn on the VPP voltage in the circuit.
And, the results will be display during the test time. To stop this test, turn off the
mode switch or pressing C key.
[DISPLAY] VPP test
0 : Vpp Low X : Any number
1 : Vpp High
7-8. To exit the diagnostic test
To escape the diagnostic test mode, execute " INITIALIZE (MAC)operation".
In case of error, the print will
be " Fiscal Error".
Error code
Balance of write test area
After fiscal system, it will change to "0000".
Balance of GT write area
The charactors will be changed to "Real ID" after
set the ID Number.
X X X X X X X X X
X X X X X X X X X
To Next Page
Loading...
