Casio FX-730P - Pass

PASS
Function:
"Password"
Character
string
Specifies or cancels a password.
Parameter:
Password:
1 ~character string~ 8.
Explanation:
6-1 Manual Commands
1) If this command is executed when a password is not specified, a password is
specified for all program areas (PO~ P9).
2)
If this command is executed while a password is specified, this password is
canceled only when entering the corresponding password. When passwords do
not correspond, a protect error (Error 8) occurs.
3) A password consists
of a 1 ~ 8 character string in which spaces, alphabetical
characters, numerals, special symbols, etc. can be used.
However,(") cannot
be used.
4) While a password
is specified, commands such as LIST, LIST ALL, LIST #,
LIST V, NEW, NEW ALL, and NEW# cannot be used. Also no writing (WRT
mode) can be made; it
is attempted, an error (Error 8) occurs.
5)
Can.not be used in a program.
6) A password can be maintained while the power switch
is off.
7)
If a program is stored on a cassette tape by a SA VE or SA VE ALL command
while a password
is specified, this password is also stored. When a program
with a password attached
is loaded from a cassette tape by a LOAD or LOAD
ALL command, the password is also loaded. Also, when a currently specified
password in the mainframe and the password
of a program loaded from a
cassette tape are different, the program cannot be loaded from a cassette tape
(Error 8).
103