8
CHAPTER
1 General Guide
•
Mode
Key (
~
)
When specifying a computer mode or an angle unit, use this key in combination
with GJ,
~-~.
~GJ·
· · · · · This turns the key input buzzer sound on and off. When the
buzzer
is
on, the "BUZZER" symbol lights up on the display.
~~·
···· · The "RUN" symbol
is
displayed for manual and program calcula-
tions. (RUN mode)
~CTI
··
· · · ·
The "WRT" symbol
is
displayed for program writing, checking
and editing. (WRT mode)
~~·
· · · · · The "TRACE ON" symbol
is
displayed for execution
of
tracing.
(For details,
see
page 71.)
~~
·
· · · · · When the "TRACE ON" symbol
is
displayed, the execution trace
mode
is
canceled and "TRACE ON" disappears.
~~
·
· ·· · · The "DEG" symbol
is
displayed specifying "degrees"
as
the angle
unit.
~§·
··· ·· The "RAD" symbol
is
displayed specifying "radians"
as
the angle
unit.
~(§]·
··
·
··
The "GRA" symbol
is
displayed specifying "grads"
as
the angle
unit.
~CZI
·
· · · · · The "PRT ON" symbol
is
displayed and printer
output
is
possible
when a printer
is
connected to the computer.
~[§)·
· · · · · When "PRT ON"
is
displayed, the printer
output
mode
is
can-
celed and "PRT ON" disappears.
~~
··
····The
"~8"
symbols light up
to
indicate that the
MEMO
IN
mode
is
specified. This mode permits memo data input to the
DATA BANK. (For details,
see
Chapter 7.) To cancel this mode,
press
~~
.
To Next Page
Loading...
Need help?
General
