Example: Transform the value 1234 to engineering notation, shifting the
decimal mark to the right, and then to the left.
1. Input 1234, and then press .
2. Perform the operation below to enter the ENG Conversion Mode.
– [ENG Notation]
• Entering the ENG Conversion Mode converts the calculation result to
engineering notation and causes to appear to its right.
• In the ENG Conversion Mode, you can use and to shift the
decimal point of the mantissa.
3. To exit the ENG Conversion Mode, press .
• This exits the ENG Conversion Mode and causes to disappear from
the display.
• You can also exit the ENG Conversion Mode by pressing or .
Note
• Normal calculations are not possible while in the ENG Conversion Mode. To start a
new calculation, exit the ENG Conversion Mode.
44
To Next Page
Loading...
