Casio fx-8200 AU - Creating a Number Table; General Procedure for Creating a Number Table

• Pressing again or pressing or returns to the parameter input
screen in step 3 of this procedure.
• You can store the currently displayed calculation result to a variable.
For example, performing the following operation while the screen in
step 4 is displayed above will store the calculation result to variable A:
– [A=] > [Store]. For details about variables, see "Variables (A, B,
C, D, E, F, x, y, z)" (page 35).
Creating a Number Table
You can use the Table app to create a number table based on the defining
equations registered for functions f(x) and g(x).
General Procedure for Creating a Number Table
Example : To generate a number table for the functions f(x) = x
2
+
1
2
and
g(x) = x
2
-
1
2
for the range -1 ≤ x ≤ 1, incremented in steps of 0.5
1. Press
, select the Table app icon, and then press .
• This displays the number table screen.
• If a defining equation is not registered for either or both of f(x) and
g(x) and the data at the cursor selection position is empty, a message
will appear at the bottom of the screen indicating that the defining
equation is not registered.
2. Configure settings to generate a number table from two functions.
(1) Press
, and then select [Table Type] > [f(x)/g(x)].
(2) Press
.
• For information about settings, see "Maximum Number of Rows in a
Number Table According to Table Type" (page 87).
3. Register a defining equation for f(x).
– [Define f(x)/g(x)] > [Define f(x)]
1 2
(Screen immediately before you pressed )
86