• You can continue to input f(x) and g(x) values for x. Each time you
input a value, the calculator determines whether it is true.
5. To disable Verify and end the Verify operation, press
and then select
[Verify OFF].
• This causes the indicator to disappear from the screen.
• For details about the operation to disable Verify, see "To disable
Verify" (page 60).
• Any changes you made to or new values you input into the x-column
values of the number table screen while Verify was enabled are
retained. When you disable Verify, the f(x)- and g(x)-columns are
recalculated in accordance with the values in the x-column.
Note
• If the verification result is "True", the value input into the f(x)- or g(x)-column can be
stored to a variable. For example, performing the following operation while the screen
in step 4 is displayed above will store 1.5 to variable A:
– [A=] > [Store]. For
details about variables, see "Variables (A, B, C, D, E, F, x, y, z)" (page 35).
• You can change the value in a cell by moving the cursor to the cell in column x and
inputting a new value. Changing the value in an x cell causes the values in columns
f(x) and g(x) to be deleted.
• You can also input a value into an x-column cell that does not contain a value (if the
maximum number of rows is not exceeded yet). For information about the maximum
number of rows, see "Maximum Number of Rows in a Number Table According to
Table Type" (page 87).
• Pressing while Verify is enabled disables Verify and simultaneously deletes all
data currently input in the number table.
To delete all the contents of the f(x)- and g(x)-columns
When Verify is enabled, the contents of the f(x)- and g(x)-columns can
be batch deleted. On the number table screen, perform the following
operation:
– [Edit] > [Delete f/g Column].
Data Retention
Doing the following will discard some data and clear some settings of the
Table app.
① Returning to the HOME screen and launching another calculator
app.
② Pressing
.
③ Changing the Input/Output setting with the SETTINGS menu.
④ Changing the Table Type setting with the TOOLS menu.
The table below shows which data is discarded and which data is retained.
91
To Next Page
Loading...
Need help?
General
