1-8
U
Press ).
Cursor is positioned automatically at the
location of the cause of the error.
Make necessary changes.
B@
Execute again.
U
I Using the Clipboard for Copy and Paste
You can copy (or cut) a function, command, or other input to the clipboard, and then paste the
clipboard contents at another location.
• The procedures described here all use the Linear input/output mode. For details about the
copy and paste operation while the Math input/output mode is selected, see “Using the
Clipboard for Copy and Paste in the Math Input/Output Mode” (page 1-18).
S To specify the copy range
1. Move the cursor (
I
) to the beginning or end of the range of text you want to copy and then
press G(CLIP). This changes the cursor to “ ”.
2. Use the cursor keys to move the cursor and highlight the range of text you want to copy.
3. Press (COPY) to copy the highlighted text to the clipboard, and exit the copy range
specification mode.
The selected characters are not
changed when you copy them.
To cancel text highlighting without performing a copy operation, press ).
S To cut the text
1. Move the cursor (
I
) to the beginning or end of the range of text you want to cut and then
press G(CLIP). This changes the cursor to “ ”.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
