Changing the Sound During a Performance
EN-70
■ Expression Pedal Calibration
When connecting an expression pedal to the EXPRESSION/ASSIGNABLE jack for the first time,
perform calibration (adjustment) as follows.
1.
Connect an expression pedal to the EXPRESSION/ASSIGNABLE jack.
2.
Select the “13 KB Setting” of the F button set. See “To change the F Button Set”
(page EN-32).
3.
Touch the F3 button (PEDAL).
The “EXP/ASGN. PEDAL” screen appears.
4.
Touch the top or bottom of the touch ring to select “Exp Calibration” then touch
the ENTER button.
A confirmation screen will appear. To cancel the operation, touch the left (NO) of the touch ring.
5.
To start calibration, touch the right (YES) of the touch ring.
6.
When “Highest” is displayed, press the toe end of the pedal down as far as it will
go, then touch the ENTER button.
7.
When “Lowest” is displayed, press the heel end of the pedal down as far as it will
go, then touch the ENTER button.
When calibration has successfully completed, “Complete” is displayed.