Saving and Recalling Performance Setups (Registration)
EN-91
Registrations can be sequentially recalled using a pedal connected to the EXPRESSION/
ASSIGNABLE jack.
1.
Connect a pedal to the EXPRESSION/ASSIGNABLE jack.
• Make sure the pedal type corresponds to the connected pedal (see “To specify the pedal type”
(page EN-68)).
2.
Refer to “To select freeze items” (page EN-90) to switch the “Pedal/Wheel”
setting to “On”.
3.
Refer to “To enable or disable freeze” (page EN-90) to turn on the Freeze
function.
4.
Refer to “To specify the pedal function” (page EN-69) to change the value of
“Pedal Target” to “Seq Recall Inc” or “Seq Recall Dec”.
5.
Step on the pedal to recall a registration.
• When the set value is “Seq Recall Inc”:
Briefly stepping on the pedal recalls registrations in ascending order of “bank number –
registration number” (i.e., 1-1, 1-2, 1-3, 1-4, 2-1, 2-2...). Stepping on the pedal and holding it
recalls registrations in reverse order (i.e., 2-2, 2-1, 1-4, 1-3...).
• When the set value is “Seq Recall Dec”:
Briefly stepping on the pedal recalls registrations in descending order of “bank number -
registration number” (i.e., 24-4, 24-3, 24-2, 24-1, 23-4, 23-3...). Stepping on the pedal and
holding it recalls registrations in reverse order (i.e., 23-3, 23-4, 24-1, 24-2...).
Using a Pedal to Cycle Through Multiple Setup Registrations (Sequential
Recall)
To Next Page
Loading...
