Casio XJ-UT312WN User Manual

73
You can use special wall mounting hardware to mount the projector on a wall. In this configuration, the
projector should be mounted with the top of the projector downwards.
For full details, contact the retailer where you purchased the projector.
Important!
 When mounting the projector on a wall, make sure that it is at least one meter away from fire
detectors, fire alarms, and other fire protection devices. Locating the projector too close to a
fire protection device creates the risk of mis-operation of the device due to warm air
exhausted from the projector. Also, avoid locating the projector close to fluorescent lights or
other strong light sources. Bright light can shorten the operating range of the remote controller
or even make remote control impossible. When selecting a location for the projector, be sure
to test for proper operation of the remote controller.
 The vertical and horizontal orientation of the projected image is reversed from normal when
the projector is positioned upside down for mounting on a wall. You need to change the setup
of the projector in order to correct for this. For details, see “Screen Settings 3 Ceiling Mount”
(page 58) under “Setup Menu Settings”.
The projector can be hung from a ceiling. When hanging a projector from the ceiling, you can orient it
upside down or with the projection lens facing straight downwards.
For full details, contact the retailer where you purchased the projector.
Important!
 When hanging the projector from a ceiling, make sure that it is at least one meter away from
fire detectors, fire alarms, and other fire protection devices. Locating the projector too close to
a fire protection device creates the risk of mis-operation of the device due to warm air
exhausted from the projector. Also, avoid locating the projector close to fluorescent lights or
other strong light sources. Bright light can shorten the operating range of the remote controller
or even make remote control impossible. When selecting a location for the projector, be sure
to test for proper operation of the remote controller.
 The vertical and horizontal orientation of the projected image is reversed from normal when
the projector is positioned upside down for hanging from a ceiling. You need to change the
setup of the projector in order to correct for this. For details, see “Screen Settings 3 Ceiling
Mount” (page 58) under “Setup Menu Settings”.
Mounting the Projector on a Wall (XJ-UT Series)
Hanging the Projector from a Ceiling (XJ-F Series)

Casio XJ-UT312WN Specifications

General

Number of colors	1.073 billion colors
Native aspect ratio	16:10
Projection distance	0.06 - 0.4 m
Vertical scan range	50 - 85 Hz
Horizontal scan range	15 - 91 kHz
Projection technology	DLP
Contrast ratio (typical)	20000:1
Screen size compatibility	50 - 110 \
Projector native resolution	WXGA (1280x800)
Keystone correction, vertical	-5 - 5 °
Noise level	37 dB
Password protection	Yes
Light source type	Laser/LED hybrid
Service life of light source	20000 h
Focus	Manual
Offset	70 %
Fixed focal length	4.2 mm
Aperture range (F-F)	2.3 - 2.3
Full HD	-
Supported video modes	480i, 480p, 576i, 576p, 720i, 720p, 1080i, 1080p
Analog signal format system	NTSC, PAL, PAL 60, PAL M, PAL N, SECAM
Supported graphics resolutions	1920 x 1200 (WUXGA)
HDMI connector type	Full-size
Serial interface type	RJ-45, RS-232C
USB 2.0 ports quantity	2
S-Video inputs quantity	0
Wi-Fi standards	802.11b, 802.11g, Wi-Fi 4 (802.11n)
Cables included	AC
Operating temperature (T-T)	5 - 35 °C
Operating relative humidity (H-H)	20 - 80 %
AC input voltage	100 - 240 V
AC input frequency	50 - 60 Hz
Power consumption (standby)	0.23 W
Power consumption (typical)	170 W
Built-in display	No
Placement	Ceiling
Product type	Ultra short throw projector
Product color	White
Market positioning	Short throw
Cable lock slot type	Kensington
RMS rated power	16 W

Weight and Dimensions

Depth	333 mm
Width	338 mm
Height	141 mm
Weight	5900 g