28 Method - Create, Edit and Delete
dilution factor. This analysis requires an external balance to be connected to the SMART 6.
3.5. Designate the desired unit of measurement (Moisture or Solids) by toggling Calculation Mode. This
will be the unit displayed rst in databases and printouts, but both Moisture and Solids values can be
accessed for any sample.
3.6. Once the method settings have been selected, press either the arrow in the bottom right corner of the
screen or the tab on the left of the screen to access Method Stages.
4. Select the “Stages” tab.
4.1. Select the Plus icon to create additional new stage. For multi stage methods, return to Stages after
determining the method parameters to create additional stages. If the method is to be a single stage
method, do not return to the Stages tab.
To Next Page
Loading...
Need help?
General
