7 - 2 Balancer mode
As the calibration is normally a laborious procedure, the parameters derived should be
memorized, then called in the case of subsequent maintenance work on the same machine.
This is possible via the balancing programs: a program is defined with a series of settings in
order to work on a particular rotor and it contains all the information and data acquired
regarding such rotor. It is possible to save the current program at any moment in a special
archive so that it is available at later dates.
N.B.
If it is required to use data and parameters of a previously stored program, it is
essential to mount the transducer in exactly the same position on the rotor.
Selection of the balancing program
When the balancing function is selected, a page is presented to the operator in which to
select the balancing program to be used, choosing between the following options:
– New program
– Loading of program from archive
– Use of current program (only available if a program has been previously created or
loaded)
To Next Page
Loading...