CENTURION SYSTEMS WIZO-LINK - Network Master Process; Adding Additional Devices or Device Federation

page 20
www.centsys.com
QUICK START SECTIONSECTION 4
3. An amber LED will illuminate indicating the channel scanning phase, followed by
a red LED.
4. The network is now ready for more devices to be added.
6. Press the NET button to exit Federated mode.
The static illuminated red LED indicates that the device is ready but that no
other devices have been found on the network.
To add additional WiZos, repeat the steps above.
If the above steps result in the WiZo returning a long beep, this WiZo has
already Federated (added to a network) and cannot be used as a master unless
it is master cleared or reset.

4.5.2. Adding Additional Devices or Device Federation
Mastering a WiZo for a new network needs to happen only once. As soon as one other
(and any additional) WiZosareaddedtothisnetwork,theyinherittheconguration
information, which may be replicated without the original master from here on.
In other words, even if the Master falls away, the network remains functional and can be
expanded.
Mastering a WiZo for a new network needs to happen only once. As soon as one other
(and any additional) WiZosareaddedtothisnetwork,theyinherittheconguration
information, which may be replicated without the original master from here on.
In other words, even if the Master falls away, the network remains functional and can be
expanded.
Pre-step
1. Ensure that all the devices that the user wishes to add have been master cleared and
have not previously been added to another network.
2. Ensure that the temporary master has been powered up.
3. Ensure that the WiZos (more than one can be ready) are powered up.
Start
To add new devices, start with the Master WiZo or any device already added if there is
more than one, and do the following;
1. Press and hold the NET button until a single beep is heard.
2. Release the button and all Federated WiZos will beep simultaneously; this indicates
that the network is in Federated mode.
3. Using a WiZo that is not currently added to any network, press and hold the NET
button until a single beep is heard.
4. Once released, the WiZo will search for the network and, once it adds the devices,
 LEDswillashandtheBuzzerwillbeepatthesamerate.
5. A new WiZo has now been added.