chapter 5000
page 105
1,2 - 2,0 t A.C.
SERVICE MANUAL
Electric
036-0410-07
This functions is useful to understand if a lifting problem is due to the encoder or not.
In case the truck stops or works with low speed with high consumption of current (and relevant alarm code
displayed on the dashboard) it is possible to disable the encoder for some seconds, no longer, given that the logic
unit cannot control the motor any longer.
Do not work with this configuration.
SLIP CONTROL (PUMP connection number 5)
Select SLIP CONTROL ON or OFF and store the
parameter pressing OUT and then ENTER to confirm.
After that switch the truck OFF and ON.
COMPENSATION
SLIP CONTROL ON/OFF
Press ROLL
Press ROLL
until reaching ALARM menu
Press ENTER
Press ENTER
Press PARAM and SET
together
Press ENTER
With the SLIP CONTROL OFF pull the lever of
the potentiometer slowly otherwise the motor
stands still.
* MENU *
SPECIAL ADJUST
* MENU *
HARDWAR E SETTING
MAIN MENU
PARAM. CHANGE
MAIN MENU
ALARM
DESCRIPTION OF THE
ALARM CODE
AC2P2B D CE 1.06
48V 350A 00000
To Next Page
Loading...
Need help?
General
