Cessna T182 Series User Manual

MODEL
182 & T182
SERIES
SERVICE
MANUAL
16-92.
PEDESTAL LIGHTING.
16-97. PITOT
AND STALL
WARNING HEATERS.
16-93. DESCRIPTION. The pedestal lighting con- 16-98. DESCRIPTION. Electrical heater units are
sists of
two lights. One
on the upper poriotn
of the
incorporated
in some pitot
tubes and stall
warning
pedestal
for lighting
of the trim wheels
and the cowl
switch
units. The heaters
offset the
possibility of
flap control. One on
the lower portion for lighting
ice formations
on the pitot tube
and stall warning
of
the fuel selector.
Light dimming
is controled
by actuator
switch. The
heaters are integrally
mounted
the transistorized light
dimming circuit.
in the pitot
tube and the stall warning
actuator switch.
Both heaters are operated
by the pitot heat
switch.
16-94.
REMOVAL
AND
INSTALLATION.
For
removal
and installation of the lamps see figure 16-13. 16-99. CIGAR LIGHTER.
16-95.
STALL WARNING SYSTEM.
16-100. DESCRIPTION. The cigar lighter
(located
on the
instrument panel) is equipped
with a thermal-
16-96. DESCRIPTION.
The stall warning
circuit is
actuated circuit
breaker which
is attached
to the rear
comprised of a warning
horn and an actuating
switch of the
cigar lighter. The circuit
breaker will open
if
The switch
is installed
in the leading edge
of the left
the lighter
becomes jammed
in the socket
or held in
wing and is actuated by airflow over the surface
of position too long. The circuit
breaker may be reset
the wing. The switch
will close as a stall
condition by
inserting a small probe
into the .078 diameter
is approached,
actuating
the warning
horn which is
hole in
the back of the
circuit breaker
and pushing
mounted
on the glove
box. The
stall warning
unit
lightly until
a click is
heard.
should
actuate the stall warning
horn approximately
five to ten miles per hour above
the airplane stall
speed.
Install the lip of
the warning unit approxi-
mately one-sixteenth of
an inch below the centerline Make
sure the master switch is "OFF" before
of the wing
skin cutout. Test
fly the aircraft to
inserting
probe into the circuit
breaker on
determine
if the unit
actuates the warning
horn at the
cigar lighter
to reset.
desired speed. If the unit actuates the warning horn
at a speed in excess of ten miles per hour above stall 16-101. REMOVAL AND INSTALLATION. (See
speed, loosen
the mounting screws and move
the unit figure 16-15.)
down.
If the unit actuates
the horn five miles per
a. Ensure
that the master switch
is "OFF."
hour
below stall
speed, loosen
the mounting
screws
b. Remove
cigar lighter
element.
and
move the
unit up.
c.
Disconnect
wire on
back of lighter.
d. Remove shell
that screws on socket
back of
panel.
e. The socket will
then be free for
removal.
f. To install
a cigar lighter,
reverse this pro-
cedure.
SHOP NOTES:
16-55

Cessna T182 Series Specifications

General

Engine Type	Lycoming IO-540-AB1A5
Horsepower	230 hp
Seating Capacity	4
Service Ceiling	18, 100 feet
Takeoff Distance	1, 600 feet
Landing Distance	1, 350 ft
Type	Single-engine
Max Takeoff Weight	3, 100 lb
Wingspan	36 ft
Length	29 ft
Height	9 feet 3 inches
Fuel Capacity	92 US gal (348 L)